Project Source 74-BRT2-PSBN Instrucciones De Montaje página 6

INSTALLATION INSTRUCTIONS (continued)
11.
After installation is complete, turn on the water supply and allow both hot and
cold water to run for at least one minute to flush away any debris that could
cause damage to internal parts. While the water is running, check for leaks. If
a leak occurs, gently tighten the nut on the connection that is leaking. Turn
off the water.
CARE AND CLEANING
Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the finish
and void your warranty.
TROUBLESHOOTING
If the faucet installation doesn't deliver water properly or leaks, finding the cause and fixing it can be easy.
PROBLEM
Faucet leaks underneath
handle.
Water does not completely
shut off.
Faucet leaks around aerator.
POSSIBLE CAUSE
Bonnet has come loose or the ceramic cartridge
seal is dirty or out of place.
Ceramic cartridge discs are worn or have debris
trapped inside.
The aerator is incorrectly fitted, dirty, or small
parts inside the aerator are improperly installed.
1. Move the handle to the OFF position. Unscrew the handle
screw and remove the handle.
2. Tighten the bonnet by turning it clockwise. Move the cartridge
stem to the ON position. The leak should stop draining out
from around the cartridge stem.
3. If the leak does not stop, shut off the water supply. Remove
the bonnet by turning it counterclockwise. Lift out the ceramic
cartridge. Inspect the seal on the bottom of the ceramic
cartridge. Remove any debris from the seal. If the ceramic
cartridge seal is twisted or out of place, re-seat it. If the
ceramic cartridge seal is worn or damaged, replace the
cartridge by calling customer service.
4. Position the cartridge back into the handle body. Make sure
the ridges on the two sides of the cartridge bonnet fit into the
grooves on the two sides of the handle body. Tightly screw the
bonnet onto the handle body.
5. Reinstall the handle.
1. Shut off the water supply.
2. Move the handle to the OFF position. Unscrew the
handle screw and remove the handle.
3. Remove the bonnet. Lift out the ceramic cartridge.
4. Position the new ceramic cartridge into the handle body.
5. Tightly screw the bonnet into the handle body.
6. Reinstall the handle.
1. Remove the aerator from the spout. Inspect the black rubber
gasket inside the aerator. The rubber gasket should be flat.
2. Reinstall the aerator on the spout.
6
11
SOLUTION