Publicidad
Idiomas disponibles
Idiomas disponibles
9.3 – SYSTEM MENU
WARNING! This menu is not visible once the control unit has been installed. For further
information on the system parameters currently set on the central unit, you must access the INFO
DISPLAY
MOTOR
← ELECTROMEC. →
NUM. MOTORS
←
2
FCA1/FCA2
←
ABSENT
→
FCC1/FCC2
←
ABSENT
(***) Purchase of the optional FC-EN module is necessary.
9.4- SETTINGS MENU
DISPLAY
LANGUAGE
←
ITA
CH2 MODE
← MONOSTABLE →
RESET INSTALL
←
OK
TOTAL RESET
←
OK
- ELECTROMECHANICAL: system with electromechanical motors
- HYDRAULIC: system with hydraulic motors
- 1: for gates with one leaf (M1)
→
- 2: for gates with two leaves (M1+M2)
M1 OPEN LIMIT SWITCH / M2 OPEN LIMIT SWITCH
- ABSENT: systems without electromechanical limit switches on opening
- PRESENT: systems with electromechanical limit switches on opening (***)
M1 CLOSE LIMIT SWITCH / M2 CLOSE LIMIT SWITCH
- ABSENT: systems without electromechanical limit switches on closure
→
- PRESENT: systems with electromechanical limit switches on closure (***)
- LANGUAGE ITA: control unit in Italian
- LANGUAGE ENG: control unit in English
→
- LANGUAGE FRA: control unit in French
- LANGUAGE ESP: control unit in Spanish
- CH2 MONOSTABLE MODE: the CH2 relay closes the contact for the whole time the
associated remote control is pressed. When the key is released the contact opens.
WARNING: any interference may affect its operation.
- CH2 BISTABLE MODE: the CH2 relay maintains its status until the next time the
associated remote control is pressed.
INSTALLATION RESET: resetting of the parameters learned during the installation
process. A new installation will be required after this reset.
→
NOTE: the MANOEUVRE COUNTERS are not deleted.
FULL RESET: resetting of all the control unit parameters. This resets the control unit
to factory default values.
→
NOTE: the MANOEUVRE COUNTERS are not deleted.
MENU.
DESCRIPTION
DESCRIPTION
11
Publicidad
