Publicidad
Idiomas disponibles
Idiomas disponibles
9.5- ABOUT MENU
DISPLAY
B120Plus
←
*.*.*
MOT - NMOT - FCA - FCC
←
EL
2
N
N
WORK TIME M1
←
60 s
WORK TIME M2
←
60 s
NO. MANEUVERS
←
***
STP
FOT1
FOT2
←
PP APP TMR SA
FCA1 FCC1
←
→
FCA2 FCC2
10- INSTALLATION
The installation procedure is shown at start-up of the control unit only if it has not already been installed.
1. Start up the control unit.
2. Select Language:
LINGUA
←
ITA
WARNING! By default, the B120 + control unit is configured to operate in the following type of system:
In the case of a system other than the one mentioned above, it is necessary to modify these parameters by
intervening in the "SYSTEM MENU" (see paragraph 9.3).
NOTE: before installing the control unit, make sure you have correctly
connected the inputs and outputs, and positioned the gate leaves halfway.
FW NAME AND VERSION: product name and firmware version of the control unit.
→
SYSTEM INFO:
EL: Electromechanical OL: Hydraulic
→
N: Absent Y: Present
This menu item is only available for systems with Electromechanical motors.
M1 OPERATING TIME: operating time taken by the M1 motor to perform a complete
opening/closing manoeuvre.
→
NOTE: operating time is set to the maximum value of 60s when the control unit is not
installed.
This menu item is only available for systems with Electromechanical motors.
M2 OPERATING TIME: operating time taken by the M2 motor to perform a complete
opening/closing manoeuvre.
→
NB: operating time is set to the maximum value of 60s when the control unit is not
installed.
NUMBER OF MANOEUVRES: counter of the number of manoeuvres (closures)
→
performed during the entire life cycle of the control unit.
INPUT TESTS: Allows to check that the inputs are working properly.
SC
The name associated with the input starts flashing when its contact is open/close. (E.g.
→
a normally closed contact (NC) flashes if it is open).
LIMIT SWITCH INPUT TESTS: allows you to check the status of the limit switch inputs.
The name associated with the limit switch input starts flashing when its contact is
open/close (E.g. a normally closed contact (NC) flashes if it is open).
NOTE: inputs testable only in the presence of the optional FC-EN module.
Press the DX or SX key to select the desired language, then press ENT to confirm.
→
N° 2 electromechanical motors - FCA1/FCA2 absent - FCC1/FCC2 absent
DESCRIPTION
12
Publicidad
