Panasonic WH-SDC0309K3E5 Manual De Instalación página 11

3. Remove the top case from the bottom case.
Bottom case
4. Remove the wiring between Remote controller 3 and Indoor
Unit terminal.
Claw
(3 places)
Disconnect the
Remote controller
wiring
Mounting The Remote Controller
For exposed type
Preparation: Make 2 holes for screws using a driver.
Mount the top case.
•
Align the claws of the top case
and then align the claws of the
bottom case.
Cut here with
a nipper and
remove the burr
with a fi le.
Connect the remote
control wiring
•
Arrange the wires along the
groove of the case.
Bottom case
(Back side)
Top case
Insert the
driver and
slightly turn.
Flat-blade
screwdriver
Slide it
downwards
to unhook
Mount the bottom case to
the wall.
Wall to which the
remote controller
is fi xed
Screw
(fi eld supply)
Remote controller terminal board
Remove the coating. Approx. 6 mm
Top case
(Back side)
Remove the sheath. Approx. 180 mm.
Make sure the wiring connection is in the
correct direction.
For embedded type
Preparation: Make 2 holes for screws using a driver.
Mount the top case.
•
Align the claws of the top
case and then align the
claws of the bottom case.
Avoid the wire
being caught.
Connect the remote
control wiring
Replace The Remote Controller Cover
•
Replace the existing Remote Controller with Remote Controller
Case 7 to close the hole left after remove the Remote Controller.
1. Refer Section "Remove The Remote Controller From Indoor
Unit" for remove Remote Controller.
2. Remove the top case from the bottom case of Remote Controller
Case 7 .
Bottom case
3. Reverse the steps 1 to 4 of section "Remove The Remote
Controller From Indoor Unit" to fi x Remote Controller Case 7 on
Indoor Unit.
Mount the bottom case to
the wall.
•
Pass the wire through the hole in the
centre of the bottom case.
Screws
(fi eld supply)
Remote controller
terminal board
Remove the coating.
Top case
Approx. 6 mm
(Back side)
Bottom case
(Back side)
Make sure the wiring
connection is in the correct
direction.
Top case
Insert the
driver and
slightly turn.
Flat-blade
screwdriver
11