Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING YOUR BEER DISPENSER
> Setting The Temperature
To start, turn the temperature control knob to the maximum setting to achieve fastest cooling
quickly.'Allow the unit to run for 3 hours. Temperature range of the thermostat goes from
36°F to 45°F.
Optimum temperature for serving draught beer is between 34°F - 38°F and that is a key
factor to consider in storing and dispensing draught beer.
To turn off the Beer Dispenser, rotate the control knob to the "OFF' position.
Note: Keep an accurate thermometer handy and adjust temperature control setting as
necessary or according to your needs.
Automatic defrosting
There is no need to defrost the Beer Dispenser. Defrost water collects and passes thru the
drain outlet in the rear wall into a tray located above the compressor, where it evaporates.
NOTE:
■
If the unit is unplugged, power lost, or turned off; you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the Beer Dispenser will
not start.
CARE AND MAINTENANCE
> Reversal And installation Of the Beer Dispenser Door
This Beer Dispenser has the capability of either opening the door from the left or right side. The unit is
delivered to you with the door opening from the left side. Should you desire to reverse the opening
direction, please follow these instructions.
NOTE:
All parts removed must be saved to do the reinstallation of the door.
•
Remove both screw-type leveling legs (7).
•
Remove the three screws (8) that hold the lower right hinge (4), save hinge for later use.
•
Remove door from upper pin (1), lift it and place it on a padded surface to prevent scratching
it.
•
Using a flat screwdriver remove right upper pin and transfer it to the same location on the
opposite side.
•
Remove the pin cap (2) from the left side of the upper frame of the door, and then transfer it
to the same location on the opposite side.
•
Remove inner plug (3) from upper frame of door and transfer it to the uncovered hole on the
opposite side.
•
Insert lower hinge (4) previously saved to the lower left side of the door. Before placing this
hinge, reverse the direction of the bolt-pin (6).
•
Set the door in place making sure the pin enters the bushing at the uncovered hole on the
upper frame of the door.
-•—While holding the door in the closed position, secure the lower left WngstiTtlghtening all the
screws, making sure the door is leveled with the counter top.
11
Publicidad
