Publicidad
Idiomas disponibles
Idiomas disponibles
36" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
3. Carefully push the appliance into the cabinet
against the wall. Reach for the chain from the
opening between the front legs and attach the
chain to the hook. Give a little pull to make sure
it is engaged firmly.
4. Finish screwing in the hook until there is little to
no slack in the chain. The hook should be facing
up (wall installation) or facing the back wall (for
floor installation) in the final position to ensure
the optimal locking of the chain.
WALL MOUNTING
•
Use the fasteners supplied with range to
install the anti-tip chain.
•
Freestanding unit must be pushed up against
the wall on installation. On gas units check
that the gas hose, if used, has not been
kinked during installation.
FLOOR MOUNTING
8.2
Installation of the skirting panel
Range is supplied with clip panel & skirting panel
that can be assembled to clip onto the front
feet for a more integrated and seamless kitchen
appearance.
Note: Minimum 36" of cook top install height is
required to facilitate the skirting installation. Ref
dimension "D" on page 5 for cook top height
measurement.
Clip base
1.
Assemble the clip snap onto the base.
2. Press in both assembled clip modules into the
kick panel in the orientation as shown below.
3. Make sure both clip modules are in the same
orientation after installation.
4. Clip the kick panel onto the front feet of the
appliance. Make sure the kick panel snaps onto
the larger section of the front feet.
17
Clip snap
Snap
Publicidad
