Bimar MDDP-30DEN1-QA3 Manual De Instrucciones página 17

Fax +32 030 9904733
•
Ensure that the appliance is kept far from any sources of heat (for example a gas appliance
and / or electric radiators in operation), fabrics, away from tumble dryers or anything else that may
come in contact with and / or obstruct the air intake and outlet, and ensure that the free space
around the front and rear is at least 50 cm. The surface where the appliance is used must be stable,
level since the appliance could tip over or spill drops of water.
•
Do not install the dehumidifier in environments where there are flammable products (gas,
sulphur, oil, etc.), or in a dusty environment.
•
The surface where the device is used must be stable, spacious (do not use on shelves), and
level (since the device could tip over) and where it will not be knocked. Do not use the
dehumidifier in small areas and do not place anything on top of the air outlet grid since the lack of
adequate ventilation can cause overheating.
• Position the device:
- far from any sources of heat (stoves, heaters),
flammable materials (tapestries, etc.), explosive
materials spray cans and materials that can
become deformed with heat; ensure that there is
at least 50cm of free space around the appliance.
- away from liquid containers, such as sinks,
showers, basins etc. to avoid splashing water and
to avoid it falling (minimum 2 metres). Should it
accidentally get wet or fall into a liquid, first turn
off the power outlet by turning off
the main switch on the electrical panel, and only then remove the plug from the socket. Dry
thoroughly and check that the electrical parts are not wet; if in doubt consult a qualified professional.
• If there is a fault or the appliance is not working correctly, switch it off and have it checked by a
qualified professional. Repairs done by an unqualified person can be dangerous and cause the
guarantee to become void.
• The device does not require any installation work, i.e. pre-arrangement of electrical connections /
water / anchoring / or other for its use.
•
In the event of transport, the device must remain in an upright position (for at least an hour);
obviously the tank must be completely empty and dry.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
17
Assembly page 17/61