Bimar MDDP-30DEN1-QA3 Manual De Instrucciones página 18

Fax +32 030 9904733
DESCRIPTION
The device is equipped with:
Main unit (13): air filter (5), control panel (3), exhaust nozzle for continuous tube (9), discharge spout
cap (8), wheels for easy movement (7), cable reel (11) or electric cable (12).
Description of Control Panel
There will be a beep for each change of function.
•
Button " " (A): press to turn on and to set the device on stand-by.
•
Button " " (C1) regulates the moisture and increases it, especially if pressed after the timer
button (D), increases the time.
•
Button"▼" (C2) button "▼" (C2) regulates the moisture and decreases it, but also if pressed after
the timer button (D), it decreases the time.
•
Button " " (D): this function allows you to program the operating time of start-up or
shutdown:
- to program the start-up time, put the plug in the socket, press "
will appear on the display panel; to increase the time, press "
each press will illuminate the selected time (0.5 hours - 1 hour, up to 24 hours), the display will
turn off after a few seconds once you have finished programming (e.g. if you set it to 2.0, once
this time has lapsed, the appliance will come on in continuous mode).
- to program the shutdown time, put the plug in the socket, press "
appliance will start up in continuous mode; to increase operation time, press "
led will light up (l2), press the Timer button again and the On (I1) led will light up and 0.0 will
appear on the display panel, to increase the time press "
press will illuminate the selected time (0.5 hours - 1 hour, up to 24 hours), after a few seconds
once you have finished programming the humidity percentage of the room will appear (e.g. if you
set it to 3.0, once this time has lapsed, the appliance shut down automatically).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
" and to decrease it, press "
18
Assembly page 18/61
" on the control panel and 0.0
" and to decrease it, press "
on the control panel and the
" and the Off
", each
",