Bimar MDDP-30DEN1-QA3 Manual De Instrucciones página 21

Fax +32 030 9904733
CLEANING AND MAINTENANCE
Important: before performing routine cleaning, remove the plug from the mains.
• To clean the tank, use water with a regular dishwashing detergent, and wipe with a soft sponge (do
not use steel wool or abrasive products). Rinse and dry thoroughly. The water temperature should
not exceed 40 °C. It is important that the tank is washed well and immediately after use to avoid the
formation of bacteria or odours.
• Periodically check that the air filter (5) is clean and that it is not
clogged by lint or fluff. To remove the filter, remove the air inlet
grid, as shown. To remove dust, use a brush or a vacuum cleaner,
taking care not to damage any part. If the filter is very dirty, wash it
in warm water and rinse several times. The water temperature should
not exceed 40 °C. After washing, allow it to dry completely before
replacing it. Do not wash it in the dishwasher. The filter light comes
on every 250 hours of use. To reset it after having cleaned the filter.
press the filter button and the light will go off.
• Do not use the dehumidifier without a filter because it may fill with dirt and will thus not work its
best.
• The main unit and control panel must only be cleaned with a soft cloth that has been slightly
dampened either with just water and/or detergent. It cannot be washed in the dishwasher, or under a
stream of water: if the electrical parts (including the power cable and plug) get wet, dry carefully
and completely before using it again.
• For long periods of time, you should stow the unit always the device upright, away from dust and
moisture; we recommend using the original packaging.
• R410A is a refrigerant that complies with European regulations on ecology, but be careful not to
pierce the refrigeration circuit. At the end of its life, the product must not be disposed of with
household waste; it must be taken to a special collection centre.
• If you decide to no longer use the appliance, it is recommended that it is made inoperative by
cutting the power cable (first ensure that the appliance has been unplugged from the power supply),
and ensure that any parts that could represent a risk to playing children are put away.
• Do not dump non-biodegradable products; be sure to dispose of them in compliance with existing
regulations. At the end of its life, the product must not be disposed of as part of ordinary waste. It
should be handed in to specific collection centres set up by the municipality, or to retailers who
provide such a service following the purchase of a new device. Separate disposal of an appliance
prevents negative consequences to the environment and health caused by inappropriate disposal.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
21
Assembly page 21/61