Publicidad
Idiomas disponibles
Idiomas disponibles
How to use
DRAINAGE
1. Water tank
When the water tank is full, the light on the control panel will flash. The device will stop running, beep 10
times and then stop, but the warning indicator on the display will remain on. Remove the water tank to
empty the water and install it as shown in the pictures below.
2. Continuous drainage
Water can be drained continuously by connecting a
water pipe at the rear (internal diameter of 9 mm).
Check if the pipe is stably connected to the drain
port to prevent water from draining out.
Note: Make sure that the water pipe is not too long
(usually 1m or 1.5m) and that the height cannot
exceed the height of the drain port to avoid water
leakage.
MAINTENANCE
Unplug the unit before transporting and/or cleaning. Disconnect the
power plug if the appliance is not to be used for a long period of time. Do
not use chemical solvents such as alcohol, petrol or benzene to clean the
appliance.
If the water tank becomes mouldy, clean it with a soft cloth.
Use a damp cloth to clean the device, do not use chemical solvents.
Clean the filter with water at least every two weeks. It is not necessary to use
hot water or chemical solvents.
STORAGE OF THE DEHUMIDIFIER
If the dehumidifier is not going to be used for a long period of time:
1. Empty the water tank completely and make sure that there is no more water stored inside.
2. Unplug the unit and bend the power cord.
3. Remove and clean the air filter, allow it to dry completely and reinstall it.
4. Store the dehumidifier in a cool, dry place, away from direct sunlight, extreme temperatures and ex-
cessive dust.
28
English
infiniton.es
Publicidad
