Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Instructions for setting and parameterizing the machine
Turn the knob to adjust the current.The display will show the adjusted current value.
Preparation for applying manual metal arc welding (MMA/SMAW)
Connect the work clamp (ground) to the piece to be welded. Make sure there is a good electrical connection in the
equipment. Remove any rust, paint, or any contamination using a wire brush or polisher (grinder, angle grinder) before
connecting.
If you use a metal table for welding, you should regularly check the connection of the work clamp (ground) for signs of
contamination or corrosion. A good ground connection is essential for good results in the welding application.
Electrode ignition
Insert the electrode into the jaw of the electrode holder by pressing the lever on the electrode holder. Make sure you
have proper eye protection (face shield) before you start welding.
Note: UV radiation damage is particularly high during arc start.
To start the arc, scratch the electrode over the spot to be welded in a similar way to how a match is lit. The 65V no-load
voltage ignites the electrode quickly, and direct current (DC) allows the electrode to melt evenly. If you are a beginner do
not expect good results on the rst attempt, take training courses and courses in welding.
Bonded electrode (ANTI STICK)
If the electrode does not ignite, or the arc goes out while the electrode is being welded, it may stick to the part to be
welded. This situation is detected by the electronic board of the equipment and the welding current is automatically
reduced. This allows you to free the stuck electrode from the surface to be welded by moving it back and forth.
While the electrode is attached, a protection is activated, driving output current near to 0. A short circuit between the
electrode holder and the ground is indicated in the same way. If the electrode cannot be detached, separate the
electrode holder and remove it manually using the appropriate protection and tweezers. Be careful as the electrode can
be very hot.
13
YEAR
WARRANTY
Publicidad
