Publicidad
Idiomas disponibles
Idiomas disponibles
<When no buzzer sounds but malfunction is suspected>
Symptom
Main switch is "ON" but
does not work
Main switch is "ON" and
pressed Loading assist
button but does not work
Product does not
function
Tying is not proper
Twisted off
Tension is too loose
Tie form is notably
deformed
Increased frequency of
jamming
Possible cause
Dead battery
Auto Power-off feature operated
Wire is touching rebars while tying
Rebar size is not applicable
Torque dial is too tight
The tied section is not on the
Center mark (Fig.24.a)
Rebar size is not applicable
Torque dial is too loose
Worn or broken parts
Switch to a new battery and confirm
whether it works.
Try switching the Main switch (Fig.1.f)
from OFF to ON.
Tie so that wire is not touching rebars.
Use with supported rebars diameters.
Adjust Torque dial (Fig.1.c).
Align the Center mark to the center of
the crossed rebars and pull the trigger.
Use with supported rebar diameters.
Adjust Torque dial tighter (Fig.1.c).
Immediately discontinue operation and
set the Main switch (Fig.6.f) at "OFF",
and remove the Battery pack (Fig.6.5)
before consulting. Then contact the
dealer where the tool was purchased or
MAX CO., LTD. authorized distributors.
23
Procedures to follow
Publicidad
