12. OPERATING INSTRUCTIONS
1. How to set the Tiewire
(Fig.6) Set the Main switch (f) at "OFF", the Trigger lock (2) at "LOCK" and remove the Battery
pack (5).
CAUTION
• Wear safety gloves.
• Be careful not to drop or give a strong impact to the Tiewire. It may cause the damage and the
malfunction of the tool.
• Beware of the tip of the wire when you pick up the Tiewire. It might cause an injury.
1-1 (Fig.9) Press the Release button (8) of this tool, and confirm that the Release button is caught in
the Release stopper (9).
1-2 (Fig.10) Stretch out the tip of the wound Tiewire.
• BE SURE TO USE ONLY THE SPECIFIED TIEWIRE (MAX TW1061T Series).
The use of binding wire that has not been specified may cause breakdown of this tool. Therefore, be sure
only to use the specified MAX TW1061T series.
RB443T is not compatible with TW898 series or TW1525 series.
• MAX TW1061T SERIES Tie Wire ARE PATENTED.
Patent numbers are listed on the back cover of this instruction.
• DO NOT USE RUSTY WIRE.
The use of the rusty wire may cause functional trouble of the tool.
1-3 (Fig.11) Rotate the Magazine stopper (6) 45° counterclockwise.
1-4 (Fig.12,13) Open the Magazine cover (r) and set the Tiewire in the Magazine (7) with the Holding
slot (x) side of the reel facing up.
1-5 (Fig.13) Hold the tip of the wire, remove the wire from the Holding slot, and feed the wire on the
outside of the Wire feed support (s).
NOTICE
The 2 wire tips of new Tiewire are twisted.
1-6 (Fig.14,15) Straighten out the tip of the wire, and insert the twisted wire into the Wire guide (l)
parallel.
1-7 (Fig.16) Confirm through the Window that the twisted part of wire has reached past two Feeding
gears (k).
1-8 (Fig.17) Press the Release stopper (9) up, and confirm that the Release button (8) has been
raised up.
1-9 (Fig.18) Close the Magazine cover and rotate the Magazine stopper 45° clockwise.
17