Harken INTCLHRW500KIT Manual De Instrucciones página 43

Installation procedure of Top-Crank LokHead Rigging Winch 500 (INTCLHRW500KIT)
Il Top-Crank LokHead Rigging Winch 500 can be used by means of the plate fixing in various manners:
ratchet belts, snap shackles, or 4 M10 screws, creating a lifting solution that is really universal and
adaptable.
The installer is responsible for choosing the appropriate screws, taking into account the loads they will
have to bear.
Harken shall not be liable in the event of improper installation of the Winch or plate or in the event of
improper use of the fixing screws.
WARNING!
The use of an incorrect number or type of fixing elements or the incorrect resistance of the mounting
surface may result in a sudden and unexpected failure of the Winch in the event of high loads, with
consequent serious injury or death.
Example of Winch anchorage by means of the 4 ø 11 holes present on the plate (figure 16.10).
Place the Winch base in the area selected and mark the holes or use the drilling template (figure 16.2).
Use 4 M10 countersunk screws of suitable length. Install the Top-Crank LokHead Rigging Winch 500
plate, fixing it with 4 M10 screws, washers and nuts on a flat surface withstanding a load of 2400 kg.
Example of Winch anchorage by means of the 2 straps in the plate holes (figure 16.11).
Example of vertical Winch anchorage by means of the strap in the side plate holes (figure 16.12).
The structure on which the plate is fixed must be bigger than the width of the plate to prevent
deformations. Ensure that the plate is securely attached to the mounting surface, so that it can operate
under load without significant movement.
17. USE
USING THE WINCH (ALL VERSIONS) - CHECKING THE WINCH BEFORE USE
Before and after each use, visually inspect the Top-Crank LokHead Rigging Winch 500 and the plate
for signs of wear, damage or breakage. If there are any signs, do not use the machine. If the worn or
defective parts are not promptly replaced, the manufacturer shall not be liable for any accidental
damage that may result. Check that all the plates, labels and indications on the machine can be read
clearly. In the event of damage, removal, or if they cannot be read any longer, they must be promptly
restored. Check the mobility of the lid (see figure 17.1).
Make sure that, rotating the knob, the upper rope grab opens and returns to the release position of
the knob (see figure 17.2).
43 22/06/2023