Publicidad
Idiomas disponibles
Idiomas disponibles
Training & Qualifications
Only workers trained and qualified should use this tool,
especially in a live line environment. It is recommended
at least a second trained and qualified person is present
at appropriate distance to respond if needed. Follow all
training and proper job site safety precautions outlined
by your industry, government and employer.
Pre-Operation Inspection
• Daily before use, inspect the tool and correct
any problems before using. If any problems are
found, do not use this tool until the problems have
been fixed. Failure to follow these steps increases
the risk of injury.
• Keep handles and grasping surfaces dry, clean
and free from oil and grease. Slippery handles and
grasping surfaces do not allow for safe handling
and control of the tool in unexpected situations.
1. Clean any oil, grease, or dirt from the body and
buttons. A clean tool aids inspection and helps the
operator observe the lights to see the status of the
tool.
2. Look for wear or damage, such as cracks, gouges,
or chips to housing.
3. Check for the presence and condition of decals.
4. Inspect the patch and foot switch cords for damage
and disentangle before use. Never use the cord for
carrying, pulling or unplugging from equipment.
Keep cord away from heat, oil, sharp edges or
moving parts. Damaged or entangled cords increase
the risk of electric shock.
5. For Endpoint mode: Check that the foot switch is
present and in good condition and does not stick
when depressed on.
6. Inspect any other equipment in the system according
to their instruction manuals.
7. Check work area for adequate lighting, a clear, level,
stable and dry place for all equipment.
10
Wireless Mode
The blue Wireless LED indicates information related to
wireless connection status. The Pull Connect wireless
technology connects to the Greenlee®Link app using a
smartphone or tablet running iOS or Android operating
systems.
To enable wireless connection to the Greenlee® Link app:
1. Download the appropriate Greenlee® Link app to
your device by going to Greenlee.com/apps, the
Google Play Store or the Apple App Store.
2. Turn ON Pull Connect, wait for start up sequence to
finish and Mode Select LEDs start flashing white. Do
not press any of the Mode Select Buttons.
3. Press the Stop Button. When the blue Wireless LED
starts flashing the unit is able to connect to the app.
(Fig. 1)
4. Go into the Greenlee Link app and follow the
instructions to select the serial number of the Pull
Connect in Wireless Mode to start pairing.
5. Wait for the Wireless LED to become solid blue
signalling the unit is connected. The Greenlee Link
app can be used to view data from the Pull Connect
and initiate firmware updates.
The Pull Connect cannot be used for Connected Pulling
while in Wireless Mode. Turn OFF Pull Connect to
exit Wireless Mode. When next turned ON follow the
instructions for the Connected Pulling Modes shown in
this manual.
© 2024 Greenlee Tools, Inc.
Pull Connect
Figure 1
52094539 REV 03
Publicidad
