ESISTYLE DUNITE 24 Manual De Instruccion página 21

BUTTON
With lights on, press
and hold «PL» button:
the light intensity starts
decreasing
increasing
reaches the minimum
or maximum
(depending on the last
PL
intensity saved). Once
the
intensity is reached,
release the button to
stop
pressing and holding
the «PL» key again, will
restart the adjustment
procedure.
With lights off, press
and hold the «PL»
button until the light
symbol on the hood
PL
control starts blinking.
Start touching the «PL»
button briefly to set up
the lights color.
To enable Clean Air
function, with hood
off, press and hold for 3
P0
seconds.
To disable the function
while it is enabled,
press «P0» button.
To enable Quick Air
Refresh function, with
hood on or off, press
and hold for 5 seconds
the «P3» button.
To
P3
function, press «P3»
button.
Note: this function has
priority over all the
other
functions.
HOOD SET-UP AND SPECIAL FUNCTIONS
ACTION
or
until it
value
LIGHT DIMMER: allows you to
adjust the light intensity
desired light
the process;
DYNAMIC LIGHT MENU: allows
you to change the color of the
light.
There are 10 (ten) different light
colors from a minimum of 2700K
to a maximum of 6000K.
Once the desired color has been
selected, in order to memorize it,
wait 10 seconds until the light
symbol on the hood control stops
blinking, and the dynamic LED
selection mode ends.
FRESH AIR FUNCTION: it can be
activated only when the hood is
off. The motor runs at the first
speed for 10 minutes and then
switch OFF for next 50 minutes and
then again, ten minutes runs and
fifty stops, all this for 24 hours
maximum.
QUICK AIR REFRESH FUNCTION:
the blower will turn on at the
maximum speed and work for 6
disable this
minutes, allowing a rapid air
renewal. At the end of the 6
minutes the blower will switch off
automatically.
active motor
FUNCTION
21
LIGHT INDICATOR
The symbol on the button
light up
The symbol on the button
light up
The symbol on the button
flashes every 5 seconds
The symbol on the button
flashes