Publicidad
Idiomas disponibles
Idiomas disponibles
A 120V, 60Hz AC-only power supply on a separate circuit with a 15A fuse is required. A time-delayed circuit
breaker that provides complete disconnection under overvoltage category III conditions, or a fuse, is
recommended. The fuse must be sized according to local codes in accordance with the electrical rating of
this unit, as specified on the serial/rating plate located inside the unit near the field wiring compartment.
WARNING!
WARNING!
WARNING!
THE ILLUSTRATIONS IN THIS BOOKLET MAY DEPICT A DIFFERENT LOOK OF THE PRODUCT,
HOWEVER, THE INSTRUCTIONS FOR INSTALLATION, OPERATION AND MAINTENANCE ARE
THE MANUFACTURERS WILL NOT TO ACCEPT ANY RESPONSIBILITY FOR EVENTUAL
DAMAGES, BECAUSE OF FAILURE TO OBSERVE THE ABOVE INSTRUCTIONS.
ELECTRICAL REQUIREMENTS
To Reduce The Risk Of Fire, Electric Shock Or Injury To
Persons, Do Not Use Replacement Parts That Have Not
Been Recommended By The Manufacturer (e.g. Parts
Made At Home Using A 3D Printer).
• ELECTRICAL GROUND IS REQUIRED ON THIS RANGE
HOOD.
• If cold water pipe is interrupted by plastic,
nonmetallic gaskets or other materials, do not use for
grounding.
• DO NOT ground to a gas pipe.
• DO NOT have a fuse in the neutral or grounding
circuit. A fuse in the neutral or grounding circuit could
result in electrical shock.
• Check with a qualified electrician if you are in doubt
as to whether the Range Hood is properly grounded.
• FAILURE TO FOLLOW ELECTRICAL REQUIREMENTS
MAY RESULT IN A FIRE.
PROPOSITION 65 WARNING FOR CALIFORNIA RESIDENTS:
This product may contain chemicals known to the State of
California to cause cancer and birth defects or other
reproductive harm.
For more informations go to www.P65Warnings.ca.gov
THE SAME.
7
Publicidad
