Zendure Hub 2000 Manual Del Usuario página 7

Dispose of old equipment (applies in the European Union and other
European countries with separate collection (waste collection))
Old equipment must not be disposed of in household waste! Every
consumer is legally obliged to dispose of old equipment that can no
longer be used separately from household waste, for example at a
collection point for recyclables.
To ensure proper recycling and avoid negative impact on the
environment, electronic devices must be taken to a collection point
in their community or district. For this reason, electronic devices
are marked with the symbol shown here.
4. Important Tips
The solar PV system is grid-tied. Please check if it is allowed in your
√
area. Depending on the region,of ficial approval may be required
√
√
√
before or after installation.
√
Hub 2000 and AB1000 should be protected from direct sunlight to
prevent rapid temperature increase.
Please check the accessories before installation, some accessories
€ need to be purchased separately.
After the installation, please first download the Zendure App to check
electricity produced and set the power to the Microinverter.
After SolarFlow installation, it will take about 5 minutes before it can
be connected to the grid, and the data will be synchronized to the
Zendure App within 20 minutes.
Before setting the output to Microinverter, please confirm the rated
power of your Microinverter, the output to Microinverter should not be
!
greater than the rated power of your Microinverter.
Please turn off the device (press and hold IOT Button for 6s to shut off
SolarFlow. If battery is SuperBase V / Satellite Battery and still working
, then also hold its Power Button for 3s to switch it off .) for removing
or installing battery .
EN
5