Zendure Hub 2000 Manual Del Usuario página 9

Bottom Aerial Port
1
2
IoT Connection: After Hub 2000 is powered on, the IoT indicator starts to
flash rapidly, and the device automatically enters the IoT connection. Users
can directly connect to IoT on Zendure App.
Tips:
• After the device is bound to Zendure Apps, when SolarFlow is turned on again, the IoT
indicator light flashes slowly until it can communicate with the Zendure App.
• If you want to re-bind the account and reset the IoT connection, please press and hold the IoT
button for 3 seconds to start the IoT connection.
• Hub 2000 & AB1000o r AB2000 or SuperBase V or Satellite Battery Hardware Reset:Press
and hold the IoT button 10 seconds to reset Hub 2000 & AB1000 or AB2000 or SuperBase V or
Satellite Battery .
Tips:
• Both Solar panels and AB1000 or AB2000 or SuperBase V or Satellite Battery power supply
can wake up Hub 2000.
• If the Hub 2000 is connected to a SuperBase V or a Satellite Battery, it is recommended that
you include at least one Solar Panel in your system, connected to the battery using an MC4 to
XT-90 cable. This will allow the battery to "wake up" even if its energy is completely drained,
as long as there is some power coming in from the solar panel.
If the battery completely drained, please follow the steps below to reactivate it.
If there is input power available, press the Power Button for 1 second on the battery to initiate
charging.
If there is no input power available, you will need to supply the battery with AC power first.
• To protect the battery, AB1000 or AB2000 will be turned off at the factory, so please activate
the battery by turning on SolarFlow for the first time (press and hold the IoT button for 2
seconds).
• Before unplugging a connection, please turn off SolarFlow .
Operation Guidelines:
Tips:
The working process of SolarFlow as follows:
First the Hub 2000 pwered on, then it will enter the working state (the Hub 2000 indicator will
lit green), second the IoT function will be awakened, and the device will directly enter Wi-Fi
connecting state (the IoT indicator flashes green), and finally, the Hub 2000 will send a signal
to activate AB1000 or AB2000 (the AB1000 or AB2000 indicator flashes green for 2 seconds
before entering a steady state).
If you're using a SuperBase V or Satellite Battery, please follow the steps below to power up
your Hub 2000 and establish the IOT connection.
1) Press and hold the SuperBase V or Satellite Battery's Power Button for 1 second to turn it on.
2) Open the Zendure App, then press and hold the IOT Button on your SuperBase V or Satellite
Battery for 3 seconds.
3) In the app, turn on the Parallel Switch to provide power to the Hub 2000.
4) Press and hold the IOT Button of your Hub 2000 for 3 seconds to finish making the
connection.
1
2
Battery Port
3
3
EN
7