Descargar Imprimir esta página

Brudden BS-500 Manual De Instrucciones página 62

Pulverizador professional de espalda com motor

Publicidad

Idiomas disponibles

Idiomas disponibles

8. TROUBLESHOOTING
Attention! All equipment maintenance, except for items listed in the Operator's Manual, must be
performed by authorized competent personnel. If the equipment problem is not identified or
persists, contact an authorized Brudden service center.
PROBLEM
Engine does not run
(does not "start")
The engine stops
abruptly (suddenly)
Engine out of power
CAUSE
Use of inferior quality fuel; Fuel
mixed with water
Lack of fuel
Clogged fuel hoses
Disconnected fuel hoses
Tank vent clogged
Clogged fuel filter
Engine soaked
Clogged air filter
Carburetor out of tune
Poor contact on the on-off switch
Excessive wear on the cylinder,
pistons, rings.
Excess carbonization in the spark
plug electrode
Spark plug electrode space out of
control
Damaged spark plug
Spark plug loose
Spark plug terminal disconnected Connect the terminal correctly
Stuck Match
Switch off
Empty fuel tank
Dirty spark plug or loose terminal. Clean or replace the spark plug; Tighten the terminal
Misfire
Water in fuel
Clogged fuel hoses
Clogged fuel filter
Tank vent clogged
Work overload
Engine stalled
Excessive wear on the cylinder,
pistons, rings.
Clogged air filter
Clogged fuel filter
Clogged fuel hoses
Air intake in fuel hoses
Carburetor out of tune
SOLUTION
Drain all fuel; Replace with good quality fuel
Filling the tank
Cleaning or replacing the hoses
Properly connect and secure hoses
Cleaning or replacing the vent
Cleaning or replacing the fuel filter
Carry out a soaking procedure (see item 7 of this manual)
Cleaning or replacing the air filter (see item 8.3 in this manual)
Contact an Authorized Service Center
Contact an Authorized Service Center
Contact an Authorized Service Center
Clean the spark plug and adjust the electrode to 0.6 mm (see
item 8 in this manual)
Adjust the spark plug electrode to 0.6 mm (see item 8 in this
manual)
Replacing the spark plug
Attaching the spark plug
Contact an Authorized Service Center
Turn on the key and start it again
Filling the tank
Contact an Authorized Service Center
Drain; Replace with new fuel
Cleaning or replacing the hoses
Cleaning or replacing the fuel filter
Cleaning or replacing the vent
Check for correct use of the equipment (refer to this manual or
contact an Authorized Service Centre)
Contact an Authorized Service Center
Contact an Authorized Service Center
Clean or replace the air filter (see item 8.3 in this manual)
Cleaning or replacing the fuel filter
Cleaning or replacing the hoses
Adjusting or Replacing the Hoses
Contact an Authorized Service Center
62

Publicidad

loading

Productos relacionados para Brudden BS-500