Publicidad
Idiomas disponibles
Idiomas disponibles
2. Key lock/unlock:
When the device is powered on, press the buttons
seconds, POF appears for a few seconds (POF=OFF setting). Once the key is locked, the POF character is
displayed for all operations except the "" key and the "UVC" key function.
When the key is locked, press the keys simultaneously
will flash and display "PON" for 3 seconds, indicating that it is unlocked.
3. Temperature adjustment operation:
When the device is powered on, briefly press the button
The temperature setting value and "SET" icon flash, press the key
setting value, release the button without pressing or by pressing the button
temperature setting, save the setting value and return to the normal ignition state.
4. Manual defrost operation:
In the normal ignition state, hold the button
manual defrost mode and the icon
met, the device will directly exit defrost mode. In defrost mode, press the button once
mode directly and return to normal operating mode.
5. Instructions for activating and deactivating UVC:
In normal boot mode, press the key
"UVC" indicator lights up, indicating that disinfection is in progress. When the UVC disinfection lamp is on,
press
for at least 5 seconds and turn off the UVC disinfection lamp.
6. Reset:
When the device is powered on, press the buttons simultaneously
for 3 seconds, indicating that all settings are restored to factory values.
7. Alarm signal instructions:
Error Code
Reason for error code
P1
Temperature sensor fault
P2
Defrost sensor fault
P3
Humidity probe fault
HA
High temperature alarm
Low temperature alarm
THERE
HHA
High humidity alarm
HLA
Low humidity alarm
Door switch alarm
dA
The alarm message remains displayed continuously until the alarm is reset. Once the audible alarm is
detected, press the ON/OFF button to eliminate the audible alarm (mute).
D. Precautions
Reducing the door opening time and opening frequency helps maintain a cold temperature inside the
refrigerator.
Never block the air intake and outlet. Maintain air circulation and refrigeration capacity.
Do not crowd the food, as this impairs the cooling effect. Adjust the height of the shelf for good food
preservation.
Allow hot foods to cool to room temperature before placing them in the refrigerator.
And
And
pressed for at least 2 seconds. The appliance goes into
lights up. After entering defrost mode, if the defrost exit condition is
for at least 5 seconds to start UVC ultraviolet disinfection. The
Resetting the alarm
Once the probe returns to normal, the alarm will
automatically stop.
When the temperature returns to normal or
defrosting is completed, the alarm will stop
automatically.
When the humidity returns to normal value, the
alarm will stop automatically.
The alarm stops automatically after the door is
closed
and hold them together for at least 3
. After 3 seconds, the humidity zone
to enter the temperature adjustment phase.
Or
To change the temperature
within one minute, exit the
And
. The buzzer will sound
EN
to exit defrost
Publicidad
