Publicidad
TO REPLACE THE STANDARD FEET ON A PREASSEMBLED HOMEBASE:
FOR FIRST TIME HOMEBASE ASSEMBLY:
REMOVE THE FEET.
A. Use the wrench to completely loosen
the draw bolts at each corner of the
HomeBase.
B. Use the wrench to remove the
M6 x 45 mm screws and washers.
C. Remove the feet from the HomeBase.
D. With the wrench that came with
your HomeBase, remove the shoulder
screws and washers and set them
aside. Then pull the support bar from
the standard foot. Repeat for the
other standard foot and the support
bar. The standard feet will not be
used, so you may either store them or
dispose of them.
B
D
Instruction #1036297A-2/7
Proceed to page 3 step 1.
REMOVE THE STANDARD FEET.
A
C
4X
4X
Proceed to page 2 step 1 (below).
4X
4X
2X
2X
Publicidad
