Publicidad
1
ASSEMBLE THE RISER FEET.
Assemble the risers onto the bar. Repeat for the second bar and risers.
Install the shoulder
screw and washer.
2
PLACE HOMEBASE ON THE RISER FEET.
Place the assembled feet on a stable surface, spaced
about 18 inches apart. With help from a friend,
carefully lower the HomeBase onto the feet.
3
ALIGN THE DRAW BOLTS.
Instruction #1036297A-3/7
4X
4X
To align the draw bolts, lift one side of the HomeBase and pull
the draw bolt down. For the front riser feet, align the draw bolt
with the rear hole of the riser foot, and for the back riser foot,
align the draw bolt with the forwardmost hole of the riser foot.
Use the wrench that came with
your HomeBase to remove the pre-
assembled standard foot. Set the
shoulder screw and washers aside.
You may either store the standard
feet for future use or dispose of them.
3 Nm
Using the provided wrench,
tighten completely to 3 Nm.
2X
2X
4X
4X
2X
2X
Publicidad
