Publicidad
Idiomas disponibles
Idiomas disponibles
Lighting System
Press "I" to turn on the lamp.
Press "O" to turn off the lamp.
This light switch can only work when the ON/OFF switch for the product is turned on.
CAUTION: Do not stare at operating lamp.
3.5.
Cleaning and maintenance
Warning! In the interests of operational safety, always switch off the saw and remove the mains
plug before carrying out maintenance work.
General
Wipe chips and dust off the machine from time to time using a cloth. Re-application of the wax coating on
the workbench makes feeding the workpiece to the blade easier. The mains cable should be replaced
immediately if pulled out, cut or damaged in any other way. Do not lubricate the motor bearings or
internal parts!
Changing the Saw Blade with pins
Switch off the saw and remove the mains supply plug before installing saw blades to avoid injuries
caused by unintentional activation of the saw.
1. Saw blade removal. Extract the sawblade by unscrewing the Clamping screw. Remove the sawblade
from the upper and lower support by slightly pressing the upper arm down.
2. Inserting the new sawblade. Lead one end of the sawblade through the perforation in the table and
insert the saw-blade pins into the notch. Repeat this procedure at the upper blade support. Before
hooking it in. Slightly press the upper arm down. Check the position of the blade pins at the supports.
EN
1 – Lamp Switch
2 – ON/OFF switch for the device
Publicidad
