Publicidad
Idiomas disponibles
Idiomas disponibles
2 - Milling notice
3 - Stop bar
4 - Upper pressure bar
5 - Lateral pressure bar
6 - Height adjustment
7 - Clamping screw
8 - Cross-cutting jig
9 - Speed adjustment
10 - Circuit breaker
11 - Right side table extension
12 - Left side table extension
13 - Overload switch
6. Assembly
Attention: Before doing any setting or maintenance work pull the power supply plug.
Fixing the machine
When using the machine it is recommended to fasten it to a work bench by means of the four holes
1) Holes must be drilled in the assembly surface, considering the spacing of the two fixing holes
in the base.
2) Each leg must be tightened with bolts (not supplied).
3) The bolts must be sufficiently long: Take into account the thickness of the working surface
onto which the machine has to be fastened.
4) Use the washers and screw the working surface on with the nuts.
5) The working surface must be sufficiently large in order to prevent tilting of the unit during
working.
Attention: Before starting work, check the solidity of the working surface.
Moulding fence components:
A.1 - Base holder
A.2 - Bracket
B - Mounting bracket
C - Fence 2x
D - Pressure bar
E - Extraction connection piece
Attachment parts for moulding fence
5 Plastic cap nuts M6
5 Washers 6mm
5 Carriage bolts M6 x 25
Table attachment
1 Carriage bolt M6 x 20
1 Carriage bolt M6 x 40
EN
Publicidad
