MSW Motor Technics MSW-WOBD-1500Y Manual De Instrucciones página 43

EN
7. Putting into operation
Attention: The spindle moulder has an axle that is placed in a vertical manner onto the horizontal
table. The axle serves for the acceptance of the moulding tools, discs and formed cutters. The spindle
moulder is used for producing friezes, simple or manifold recesses, grooves, rebates, profiles and
counter profiles on straight surfaces, etc.
With the spindle moulder, in no way cutter heads of a larger diameter than 50 mm must be used. If
larger diameters are required, we recommend working at several steps and the repeated adjusting
with the use of the height setting knob, or the step by step setting of the fence.
1. Installing and changing the clamping sleeves for top spindle moulders (Fig. 16, 13)
• Before changing the clamping sleeves, pull the power supply plug of your machine. Select the
clamping sleeve matching the diameter of your cutter head.
• Remove the reducing piece from the table opening, Fig. 14.
• Lock the spindle with the button at the bottom of the spindle, Fig. 16.
• Release the safety nut of the clamping sleeve using the key supplied, Fig. 15.
• Insert the clamping sleeve in the nut, or remove it.
• Firmly tighten the nut in the clamp while keeping the spindle locked. Before every use of the
machine make sure that the cutting tool is firmly clamped at the end of the spindle.
• Set the reducing piece for the opening back to its original position.
• Adjust the fence, as required, by means of the scale on the table.
• Connect the dust extractor unit. It is highly recommended to connect a dust extractor unit (or
system) in order to keep the opening free from chips, to cool the motor, and to facilitate the work
piece feed.
• Reconnect the machine to the power supply.