Publicidad
Idiomas disponibles
Idiomas disponibles
Switching on and off
Make sure that all keys and adjusting tools are well away from the spare desk that the attitudes are
installed in full and all safety covers are kept.
"O" – OFF
"I" – ON
This machine uses an electromagnetic switch for optimal security. Whenever the current is
interrupted the machine stops immediately.
To restart the machine the green button must be pushed again.
9. Utilization of the machine
• Insert an appropriate milling cutter in the tool holder and secure this by tightening the tool holder
nut (Fig. 17, item 14).
• Fit and secure the cutting knives.
• Adjust the speed and adjust the output fence in such a way that the material cut is supported and a
compensation for the material removed is achieved.
• Switch the machine on.
• Make sure the work piece is firmly pressed against the fence.
• Push the work piece softly from right to left against the turning direction of the tool.
• Keep your forwarding speed constant. Do not push too fast – it would slow down the motor too
much.
• Feeding the work piece too fast will result in a poor cutting quality. There is also the risk of
damaging the cutting knives or the motor.
• Feeding the work piece too slow will result in burnt spots on the work piece.
• With very hard wood and important cuts it can be necessary to work progressively in several cuts
until the desired depth is achieved.
• The correct intake speed depends on the cutter size, the material type of the work piece, and the
cutting depth. It is recommended to practise first with a piece of scrap wood in order to determine
the correct intake speed and the dimensions.
• Switch the machine off by pressing the red cover.
• The machine is fitted with an overload switch (13) to protect the motor. In the event of an
overload, the machine will cut out automatically. After a short time, the overload switch (13) can be
reset again.
10. Cleaning, maintenance
General maintenance measures
Wipe chips and dust off the machine from time to time using a cloth. In order to extend the
•
service life of the tool, oil the rotary parts once monthly.
•
Do not oil the motor.
When cleaning the plastic do not use corrosive products.
•
WARNING! Before cleaning, adjustment, maintenance or repair work, disconnect the
power cord from the main power supply!
Cleaning
• Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it with compressed air at low pressure.
• We recommend that you clean the device immediately each time you have finished using it.
EN
Publicidad
