Publicidad
Idiomas disponibles
Idiomas disponibles
EN
3. Use of the table rings
The table rings must be used in order to reduce the spacing between table and spindle to a
minimum. Before switching on the machine systematically check the table rings supplied for their
correct seat.
Check whether you have chosen the correct ring for the corresponding cutting tool and its
installation height, in order to reduce the risk of work piece tilting at passing the opening. The
reduction piece (table ring) must enclose the cutter head as far as possible.
8. Adjustments
Adjust the number of revolutions Fig. 17, 20
The speed adjustment of the machine has 6 stages.
• Determine the optimal number of revolutions by a sample cut in a piece of waste material.
Note: The use of the correct number of revolutions increases the life-span of the drill. It, also, affects
the worked surface of the work piece.
Adjust the rabbet, Fig. 18, 19
• The rabbet is to be stopped to the size of the work piece and the milling tool.
• Loosen the 2 plastic cap screws (b) on the back of the fence.
Set the stops and pressure devices such that they ensure the safe guidance of the workpiece at the
input and output section of the machine.
• Push the rabbet to the rear or forward of the desired position. Use scale (c) on the table in order to
determine the distance and take note of the drill centre.
• Re-tighten the 2 plastic cap screws (Fig. 19, b) on the back to keep the fence in this position.
Adjust the rabbet for error, Fig. 18, 19
• Error from wood is the material from wood left from the drill exiting, more thinly than the material,
on the right side.
• The left fence must be adjusted to the thinner material. It supports the material and ensures a
more exact cut. To do this, loosen the plastic cap screws, push the fence to the front and tighten it.
Publicidad
