Operating Mode / Status Description - Phasak 6000VA Manual De Uso

3.7. Operating Mode / Status Description

Operating mode
AC mode
ECO mode
CVCF mode
Battery mode
Bypass mode
Battery Test
Fault status
Segurança e harmonia
ININTERRUPTA
Description
When the input voltage is
within acceptable range, UPS
will provide pure and stable AC
power to output. The UPS will
also charge the battery at AC
mode.
When the input voltage is
within voltage regulation range
and ECO mode is enabled,
UPS will bypass voltage to
output for energy saving.
When input frequency is within
46 to 64Hz, the UPS can be
set at a constant output
frequency, 50 Hz or 60 Hz. The
UPS will still charge battery
under this mode.
When the input voltage is
beyond the acceptable range
or power failure, UPS will
backup power from battery and
alarm will beep every 4
seconds.
When input voltage is within
acceptable range and bypass
is enabled, turn off the UPS
and it will enter Bypass mode.
Alarm beeps every two
minutes.
When UPS is in AC mode or
CVCF mode, press "Test" key
for more than 0.5s. Then the
UPS will beep once and start
"Battery Test". The line
between I/P and inverter icons
will blink to remind users. This
operation is used to check the
battery status.
When UPS has fault
happened, it will display fault
messages in LCD panel.
LCD display
3. Operations
PH 9360 | PH 9301
Uninterruptable Power Supply
EN
61