Pioneer VSX-330-K Guía De Inicio página 15

Ocultar thumbs Ver también para VSX-330-K:
Tabla de contenido

Publicidad

Press DISP (e) several times to check various
settings in the following order: listening mode
volume
input audio format
input source.
#
#
You can also see which audio format is being input by
checking the indicators in the lower part of the display.
This unit is compatible with the following digital audio
formats. (with HDMI connection)
0 Dolby Digital
0 Dolby Digital Plus
0 Dolby TrueHD
0 DTS
0 DTS 96/24
0 DTS Express
0 DTS-HD MasterAudio
0 PCM (32 kHz to 192 kHz sampling frequencies)
0 SACD (DSD 2ch only)
0 DVD Audio (including 192 kHz)
Important: The listening modes may not be available
depending on the current source, settings and status
#
of the receiver.
Troubleshooting
0 When a sound can not be heard from center and
rear speakers, press ALC/STANDARD or ADV
SURR to change listening modes.
E.g.) Press ADV SURR for several times to select
EXT.STEREO.
0 In order to listen to the audio from the source
component that is connected to this receiver, press
SIG SEL to select H (HDMI cable), C1 (coaxial
cable), O1 (optical cable), or A (analog audio
cable).
0 If there is no sound from the subwoofer:
When the front speaker is set to LARGE then, in
some cases, no sound may come from the
subwoofer. Change the front speaker setting to
SMALL or change the subwoofer to PLUS and the
sound should be restored.
0 If the remote control is not responding:
- In order to control the receiver using the remote
control, first press
- In order to control TUNER or USB, first press TUNER
or USB.
0 If the power suddenly turns off:
- Check that there are no loose strands of speaker wire
touching the rear panel or another set of wires. If so,
re-attach the speaker wires, making sure there are no
stray strands.
- When Auto Power Down is set, the power
automatically turns off at the set time.
Resetting the Main Unit
Use this procedure to reset all the receiver's settings
to the factory default. Use the front panel controls to
do this.
1. Switch the receiver into standby.
2. While holding down BAND, press and hold
Í STANDBY/ON for about two seconds.
3. When you see RESET? appear in the display,
press AUTO SURROUND/STREAM DIRECT. OK?
shows in the display.
4. Press ALC/STANDARD SURR to confirm.
.
En
15

Publicidad

Tabla de contenido
loading

Tabla de contenido