Publicidad
Idiomas disponibles
Idiomas disponibles
water outlet to drain water.
• Once the internal water tank is drain,
reinstall the base stopper, make sure it
is on securely.
• Place the air conditioner in the desired
location, reconnect the exhaust hose,
and plug in the air conditioner. The unit
will operate normally.
To avoid accidents caused by
electric shock, make sure that
no power is supplied to the unit
before starting maintenance or
repair.
AIR FILTER CLEANING
If the air filter is blocked by the
accumulation of a large amount of dust,
the volume of the air flow will be reduced.
Clean the filter once every two weeks.
Open and clean the air filter (see picture 16
on page 08):
• First remove the lower grille with its
respective filter. Then the upper one
• Carefully wash the air filters by
immersing them in hot water (about 40
°C or 104 °F) with neutral detergent.
• Rinse the filter detergent and let it dry
completely in a shaded area.
• Put the air filter back in its original
place.
Notes:
• Do not use water with excessive
temperature (suitable temperature is
about 40 C) or irritant detergent (such
as alcohol, gasoline, benzene, etc.) to
clean the filter.
• To avoid deformation of the filter, the
cleaned filter should be kept away from
the heat source and put in dry air to dry
naturally.
• Do not run machines without filters.
AIR CONDITIONING CLEANING
Clean the surface of the unit with a damp
cloth. Then dry with a cloth or similar.
Do not use chemical solvents
(such as benzene or alcohol) to
clean the surface of the unit;
doing so will scratch, damage,
and even deform the entire
case.
BEFORE YOU PUT IT INTO OPERATION
• Check if the air inlets and outlets of the
unit are blocked.
• Check that the partition plate stop and
the base stop are installed correctly.
• Before turning the unit on, make sure
the air filter is in the correct position.
If the equipment is operated without
the air filter, dust and other objects
will cause the air conditioning to
malfunction.
IF IT'S GOING TO BE UNUSED FOR A
WHILE
• Turn off the air conditioner and
disconnect it from the power supply.
• Maintain the air filter and other parts
correctly.
• Open the partition plate stop and the
base stop for draining water from the
partition plate and the base. Then run
the unit in fan mode for half an hour to
ensure that the divider plate and base
are dry.
• Use a plastic sheet to cover the unit to
prevent dust or dirt from entering the
unit.
WIFI FUNCTION
Here At UniversalBlue we have
created an explanatory video
so you can easily connect the
appliance to your smartphone
using the WiFi network.
Visit our YouTube channel and access the
video following this link: https://www.
youtube.com/watch?v=4KbOXxKXQ6Y or
scan the QR code you will find on page 09,
image 18.
To control the fan via WiFi just follow the
steps below:
EN
35
Publicidad
