Publicidad
Idiomas disponibles
Idiomas disponibles
Pressure
Washer
Rinsing
,_
WARNING!
Be extremely careful if you must
use the pressure washer from a ladder,
scaffolding or any other relatively unstable
location. When you press the trigger, the recoil
from the initial spray can be very strong. The
high pressure spray could cause you to fall if
you are too close to the cleaning surface.
After you have applied detergent, scour the surface
and rinse it clean as follows:
1.
Apply safety latch to spray gun.
2.
Remove black chemical spray tip from nozzle
extension.
3.
Select and install desired high pressure spray tip
following instructions in "How to Use Spray Tips".
4.
Keep spray gun a safe distance from area you
plan to spray.
5.
Increase or decrease spray pressure by turning
pressure control knob counterclockwise
or
clockwise respectively. Use lower pressure to
wash items such as a car or boat. Use higher
pressure to strip paint and degrease driveways.
Pressure
Control
Knob
,_
CAUTION!
Firmly grasp spray gun with both
hands when using high pressure spray to avoid
injury if gun kicks back.
6.
Apply high pressure spray to small area and check
surface for damage. If no damage is found,
assume it is okay to continue rinsing.
7.
Start at top of area to be rinsed, working down
with same overlapping strokes as used for
cleaning.
Automatic
Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray
gun, circulating water in the pump can reach
temperatures above 125°F. The system engages to
cool the pump by discharging the warm water onto
the ground.
11
Publicidad
