Publicidad
Idiomas disponibles
Idiomas disponibles
AFTER EACH USE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump
parts and "freeze" pump action. Follow these
procedures after every use:
1.
Flush detergent siphoning tube by placing filter
into a pail of clean water while running pressure
washer in low pressure mode. Flush for one to two
minutes.
2.
Shut off engine, let it cool, then remove garden
and high pressure hoses.
3.
Disconnect spark plug wire from spark plug.
4.
Empty pump of all liquids by pulling recoil handle
about 6 times. This should remove most of liquid
in pump.
5.
If storing for more than 30 days see "Long Term
Storage" on next page.
6.
Disconnect hose from spray gun and high
pressure outlet on pump. Drain water from hose,
gun, and nozzle extension. Use a rag to wipe off
hose.
7.
Coil high pressure hose and inspect it for damage.
Cuts in hose or fraying could result in leaks and
loss of pressure. Should any damage be found,
replace hose. DO NOT attempt to repair a
damaged hose. Replace hose with genuine
Craftsman part.
8.
Properly hang hose on wire support provided on
handle.
9.
Reconnect spark plug wire to spark plug.
10. Store unit in a clean, dry area.
,_
WARNING!
NEVER store the engine with fuel
in the gas tank indoors or in enclosed, poorly
ventilated areas where fumes may reach an
open flame, a spark, or standing gas pilot.
WINTER
STORAGE
CAUTION!
You must protect your unit from freezing
temperatures.
Failure to do so will permanently
damage your pump and render your unit inoperable.
Freeze damage is not covered under warranty.
To protect the unit from freezing temperatures:
1.
Flush detergent siphoning tube by placing filter
into a pail of clean water while running pressure
washer in low pressure mode. Flush for one to two
minutes.
2.
Empty pump of all pumped liquids by pulling recoil
handle about 6 times. This should remove most
liquid in pump.
3.
Use PumpSaver, available at Sears retail item
number 7174403, to treat pump. This prevents
freeze damage and lubricates pistons and seals.
4.
If PumpSaver is not available, connect a 3-foot
section of garden hose to the water inlet adapter.
Pour RV-antifreeze
(antifreeze without alcohol)
into the hose. Pull the recoil handle twice.
Disconnect 3-foot hose.
16
Publicidad
