Publicidad
Idiomas disponibles
Idiomas disponibles
Yourpressure washer r equires someassembly a ndis
readyforuseonlyafterit hasbeenproperly serviced
withthe recommended oilandfuel.
If you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
IMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will result
in an engine failure.
REMOVE PRESSURE
WASHER
FROM CARTON
Remove the parts bag packed with pressure
washer.
Slice two corners at the end of carton from top to
bottom so the panel can be folded down fiat, then
remove all packing material.
Roll pressure washer out of carton.
Check carton for additional loose parts.
CARTON
CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
The Main Unit
Handle
High Pressure Hose
Spray Gun
Nozzle Extension with Quick Connect Fitting
Oil Bottles (2)
Parts Bag (which includes the following):
Owner's Manual
Owner's Registration Card
Bag containing 5 multi-colored
Quick Connect
Spray Tips
Handle Fastening Hardware Kit (which
includes):
Carriage Bolts (2)
Plastic Knobs (2)
Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration shown on page 5. If any parts are missing
or damaged, call the pressure washer hetpline at
1-800-222-3136.
ASSEMBLING
YOUR PRESSURE
WASHER
The majority of your Craftsman pressure washer was
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
1.
Fill out and send in registration card.
2.
Attach handle to main unit.
3.
Remove shipping cap and install dipstick in pump.
4.
Add oil to engine crankcase.
5.
Add fuel to fuel tank.
6.
Connect high pressure hose to spray gun and
pump.
7.
Connect water supply to pump.
8.
Attach nozzle extension to spray gun.
9.
Select/attach quick connect spray tip to nozzle
extension.
Attach
Handle
1.
Place handle assembly onto handle supports
connected to main unit. Make sure holes in handle
align with holes on handle supports.
Align Holes_
Handle
Supports
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2.
Insert carriage bolts through holes from outside of
unit and attach plastic knob from inside of unit.
Tighten by hand.
3.
Insert multi-colored
nozzles in spaces provided in
handle.
6
Publicidad
