Publicidad
Idiomas disponibles
Idiomas disponibles
VIRTUAL/UNIVERSAL TERMINAL SETUP
13. Select the ISObus tab and define additional
parameters in this screen based on your
equipment and application.
14. Press the HOME softkey to save all changes
7
8. Select the Implement tab, enter Nozzle Spacing
and Total Sections.
9. Touch the START softkey next to Actuator Auto
Config. This will automatically determine how
many ProStop-E valves are connected, and
assign one valve to each section.
10. Open the Section Configuration to ensure that
a value of "1" is next to each section. Go back to
the Implement tab if all sections comply.
11. Touch the ENTER softkey next to Cannode
Configuration. Ensure the Cannodes are
displayed in order. For example, Cannode #1
should control the leftmost ProStop-E valves,
#2 controls the center ProStop-E valves, and #3
controls the rightmost Prostop-E valves on the
machine.
12. If the Cannodes are not displayed in the correct
order, use the arrows next to each to organize
accordingly.
PROSTOP-E ISOBUS MODULE SYSTEM
Publicidad
