Install The Squeegee; Fill The Solution Tank - Nilfisk-Advance BR 850S Serie Instrucciones De Uso

INSTALL THE SQUEEGEE

1 Make sure the Squeegee (19) is up (O) and the Key Switch (J) is off (O). Hold the squeegee tool so that the curved ends point forward, then slide the
squeegee tool onto the Mount (A) (See Figure 2).
2 Hand tighten the Thumb Nuts (B) and then connect the vacuum hose to the Squeegee Tube (C) (vacuum hose should loop to the right).

FILL THE SOLUTION TANK

Read the cleaning chemical label and fi gure the proper amount of chemical to mix for a tank that holds 40 US gallons (151 liters).
Open the Solution Tank Cover (2), then fi ll the tank 1/3 full of water, add the cleaning chemical, then fi ll the tank to 7.62cm (3 inches) from the top of the tank
opening (fi ll to bottom of the wall in tank opening). NOTE: AXP/EDS machines can either be used conventionally with detergent mixed in the tank or the
detergent dispensing system can be used. When using the AXP/EDS detergent dispensing do not mix detergent in the tank, plain water should be used.
CAUTION!
Use only low-foaming, non-fl ammable liquid detergents intended for automatic scrubber machine applications. Water
temperature should not exceed 130 degrees Fahrenheit (54.4 degrees Celsius).
FIGURE 2
FRONT
revised 3/06
B
A
FORM NO. 56041583 - Adgressor
ENGLISH / A-9
C
, Adgressor AXP / BR 850S series - A-9
™ ™