Roborock Q5 Pro+ Manual Del Usuario página 12

Note: To ensure cleaning performance, replace the filter
components every 1-3 months, depending on the water
quality and how often you use the robot.
Robot Sensors
C9
* Clean monthly.
Use a soft, dry cloth to wipe all sensors,
including:
C9-1—Dock Locator
C9-2—Wall Sensor
C9-3—Four Cliff Sensors
Dust Bag Replacement
C10
* Replace as required.
C10-1— Remove the dustbin cover vertically
as shown.
C10-2— Lift the dust bag out of the dustbin
and discard it.
Note: The dust bag handle seals the bag on removal to
prevent dust leakage.
C10-3— Clean the filter with a dry cloth.
C10-4—Install a new dust bag in place
along the slot and put the dustbin
cover back.
Air Duct
C11
* Clean as required.
C11-1—Unscrew the screws (10) and remove
the cover.
C11-2—Wipe the air duct and cover with a
dry cloth.
C11-3—Reinstall the cover and screw it
back in place.
Charging Contact Areas
C12
* Clean as required.
Use a soft dry cloth to wipe the charging
contacts on the robot. Clean the dock
location beacon, charging contacts, and
electrode brushes on the dock.
Battery
The robot is equipped with a high-
performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged
during normal use.
Note: If the robot will be left unused for a long period,
turn it off and charge it at least every three months to
avoid battery damage caused by over-discharge.
12
Basic Parameters
Robot
Model Q50ULE
14.4V/5200mAh (TYP)
Battery
lithium-ion battery
Rated Input 20VDC 1.2A
Charging Time < 6 hours
Note: The serial number is on a sticker on the underside
of the robot.
Auto-Empty Dock
Model AED06HRR, AED07HRR
Rated Input Voltage
220-240VAC
Rated Frequency 50-60Hz
Rated Input
5A
(Dust Collection)
Rated Input (Charge)
0.5A
Rated Output 20VDC 1.2A
14.4V/5200mAh(TYP)
Charging Battery
lithium-ion battery