Roborock Q5 Pro+ Manual Del Usuario página 8

Power Cable Storage
A14
A14-1—Power Cable Storage Slot
A14-2—Cable Outlet
A14-3—Power Port
Note: Power cable can be pulled out at both sides.
Installation
B
Important Information
1. Tidy cables and loose items from the
ground and move any unstable, fragile,
precious, or dangerous items to prevent
personal injury or property damage due to
items becoming tangled in, struck by, or
knocked over by the robot.
2. When using the robot in a raised area,
always use a secure physical barrier to
prevent accidental falls that may result in
personal injury or property damage.
Note: When using the robot for the first time, follow
it throughout its whole cleaning route and watch for
potential problems. The robot will be able to clean by
itself in future uses.
Position the Charging Dock
B1
B1-1— Take the screwdriver from its storage
bin at the bottom of the base.
B1-2— Place dock upside down on a soft,
flat surface (carpet/towel/ cloth) and
attach the base by using the six screws
provided.
Note: Hold the dustbin cover securely when upside
down to prevent damage from falling.
B1-3— Connect the power cable to the dock,
and keep the excess cable inside the
storage slot.
B1-4— Place the dock on a hard and flat
floor (wood/tile/concrete etc.), flat
against a wall. Keep at least 0.3 m
(1 ft) of clearance on either side and
1 m (3 ft) both in front and above.
Make sure the location has good
WiFi for a better experience with the
mobile app, and then plug it in.
08
B1-4-1—more than 0.3 m (1ft)
B1-4-2—more than 1 m (3ft)
Notes:
• The status indicator light turns off automatically when
the robot is charging.
• The status indicator light turns red if an error occurs.
• Do not use without a dustbin cover or dust bag.
• Place the dock on a flat floor away from fire, heat, and
water. Avoid narrow spaces or locations where the
robot may be suspended in the air.
• Placing the dock on a soft surface (carpet/mat) may
cause the dock to tilt over and cause problems
docking and departing.
• Keep excess power cable inside the storage slot so
that the robot will not get tangled in the cables, and
the dock will not be dragged away or disconnect from
the power supply.
• Keep the dock away from direct sunlight or anything
that may block the dock location beacon; otherwise,
the robot may fail to return to the dock.
• The Auto-Empty Dock recharges and empties. Store
the standard robot dock before use. Failure to do so
may cause issues returning to dock.
• Maintain the dock according to the maintenance
instructions. Do not clean the dock with a wet cloth.
Powering on & Charging
B2
Press and hold the button to power on the
robot. When the power light goes on, place
the robot on the dock to charge. Make sure
the charging dock power indicator turns off
and a "charging" voice alert sounds. To
maintain the performance of the
high-performance lithium-ion rechargeable
battery pack, keep the robot charged.
Note: The robot may not turn on when the battery is
low. In this case, place the robot directly onto the dock
to charge.
Using the Mopping Module
B3
B3-1—Adjust the water flow
Slide the switch down to increase the water