Too much noise in FM
stereo
and
monaural
broadcasts
Preset station is reset
Station is too far, or signals are too weak
^Select other stations ot higher signal level_
The motor antenna relay control lead is not connected correctly
>=>lf there is a motor antenna in the car, connect the motor antenna
relay control lead to the motor antenna lead that is installed in the
car correctly
The radio antenna is not extended enough
■=>Extend fully the radio antenna_
Battery cable is not correctly connected
^Connect the battery cable to the terminal that is always active_
□ CD
Trouble
Disc is in the CD com¬
partment but no sound is
made, or disc is ejected
automatically
Sound skips, bad sound
quality (e g. caused by
noise)
Cause/Step_
■
•
1
N
Disc is upside down
«=>Place disc m the correct direction with the label side up
-—-—->
o Disc is dirty
o Disc has scratches
<=>Clean disc, referring to the section on "Notes on CD/CD Media
(CD-ROM, CD-R, CD-RW)"_,
3" (8 cm) disc is ejected automatically
A disc that has data other than CD-DA or MP3 type is played
pDiscs that have CD-DA type data should be used_
«=>The unit may not successfully play back a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive)
and a disc which are incompatible one another Refer to instruc¬
tions for the concerned devices for details
•*
o Disc is dirty
o Disc has scratches
=>Clean disc, referring to the section on "Notes on CD/CD Media
(CD-ROM, CD-R, CD-RW)"_
=>The unit may not successfully play back a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive)
and a disc which are incompatible one another Refer to instruc¬
tions for the concerned devices for details
m®mm
45