Publicidad
Idiomas disponibles
Idiomas disponibles
\ WARMING
This installation information is designed for experienced installers and is not in¬
tended for non-technical individuals. It does not contain warnings or cautions of po¬
tential dangers involved in attempting to install this product.
Any attempt to install this product in a motor car by anyone other than a qualified
installer could cause damage to the electrical system and could result in serious
personal injury or death.
□ Installation Hardware
No.
Item
Diagram
Q'ty
©
Mounting collar
1
©
Hex. nut (5 mm^)
1
©
Rear support strap.
X
1
Tapping screw
(5 mm0x16 mm)
1
<D
Mounting bolt (5 mm0)
&
1
(D
Power connector
1
Removable face plate
case
1
Trim plate
1
<D
Lock cancel plate
2
□ Overview
This product should be installed by a professional.
However, if you plan to install this product yourself,
your first step is to decide where to install it. The
instructions in these pages will guide you through
the remaining steps:
(Please refer to the
"WARNING" statement
above.)
o Identify and label the car wires,
o Connect the car wires to the wires of the power
connector.
o Install the unit in the dashboard,
o
Check the operation of the unit.
If you encounter problems, please consult your
nearest professional installer.
Caution:
oThis unit operates with a 12 V DC negative
ground auto battery system only. Do not at¬
tempt to use it in any other system. Doing so
could cause serious damage,
v----/
Before you begin installation, look for the items
which are packed with your unit.
(
o
Warranty Card...Fill this out promptly,
o
Panasonic Servicenter List for Service Directory
...Keep for future reference in case the product
needs servicing.
oInstallation Hardware...Needed for in-dash in¬
stallation.
□ Required Tools
You'll need a screwdriver, a 1.5 V AA battery, and
the following:
12 V DC
Electrical
Side-cut
Test bulb
tape
pliers
□ Dashboard Specifications
Thickness
Min. 3/ie" (4.75 mm)
[GQaDF«X9.7/2U]
Publicidad
