urmet domus 956 Manual De Usuario página 7

WINFLAT MONITOR
It is a CRT 4" wall monitor equipped with a new
generation flat screen and a built-in house phone. It
can be wall-fitted with no need for masonry works.
Installation is extremely simple and fast, as the
installation wires are connected to terminal strips
on the bracket to which the monitor is attached.
The monitor features a door release key and 2
service keys that can be used, for instance, for:
− stairs lamp lighting;
− release of an additional electric lock;
− silent self-insertion (in this case the system needs
an additional wire in conduit).
79
206
Service
key
Service
key
Door release
key
Call
adjustment
Contrast adjustment
Brightness adjustment
DS956-002B
Instructions for wall mounting
1. Prepare the conduit so that it terminates at the
infeed hole provided.
2. Use the 4 screws to fasten the bracket to the
wall at the height from the floor indicated.
3. Connect the conductors to the special terminals.
4. Extract the fastening hook A.
5. Insert the monitor in the bracket.
6. Fasten the monitor in place pushing hook A
inwards.
A
Max.
Med.
Min.
Instructions for mounting the table adaptation
kit
1. Insert under the base, in the special spaces of
the table support, the 4 adhesive rubber caps
which are supplied with the kit (picture 1).
2. On the base, break just of the 3 sides for cable
through as in picture 1.
3. Insert in the hole the socket cable and fix it by
the tool and the screw which are supplied with
the table kit ( see b, picture 2).
4. Fix the adaptation plate to the table support by
means of the special screws (picture 2).
5. Fix the bracket to the adaptation plate by means
of the special screws (picture 2).
6. Connect the socket conductors to the special
terminals of the bracket.
7. Pull out the stop hook A on the monitor.
8. Hook the monitor on the bracket and block it,
pushing the stop hook A towards inside.
9. Connect the conductors of the system to the
correspondent socket terminals.
a
a
Picture 1
A
13 14
POWER SUPPLY
The power supply gives the supply necessary to all
the system. It is connected to the TV camera unit by
means of 4 wires and it can be fixed to the wall or on
bar DIN.
It should be kept in a dry and weatherproof place.
a
The length of 126 mm corresponds to 7 modules of
18 mm, according to the DIN 43880 standard.
Picture 2
b
DS956-002B