urmet domus 956 Manual De Usuario página 8

TV CAMERA UNIT
The TV camera unit is mounted on Kombi modular
elements with 2 modules. It includes:
− CCD TV camera
− Infrared Led for lighting
− Embedding box
− Front plate with 1 or 2 keys
− Electronic circuit
− Lamp for lighting the name tags
The internal and external sound volumes can be
adjusted by operating on the proper controls.
To light the name tags, connect the lamp terminals
to the power supply 12 V (see the scheme).
The TV camera unit is compatible with the
accessories of the Kombi line.
126 12,5 45
57,5
PICK-UP FIELD
Vertical Horizontal
0,95
1m 1m
The TV camera unit has a fixed shooting angle, and
no vertical adjustment is possible.
DS956-002B
INSTALLATION
Wall embedded version
The video outdoor station is recommended to be
installed at a such a height that the upper part of the
TV camera unit module is 1,55 ÷ 1,65 m from the
floor.
m = 1,55 ÷ 1,65
Before embedding the box in the wall, prepare a
hole for passing the wires through. In the embedding
box containing the TV camera unit, the hole must be
opened only in the areas shown by the arrows.
The embedding box must be walled flush to the
finished plaster and must not protrude.
If the box is embedded too deeply, tighten the two
screws (on the lower side of the box) in the special
holes until the head is brought flush to the wall; this
will avoid subsequent distortions of the lower
headstock of the module frame.
1,25
Fix the TV camera unit to the embedding box as
shown in the figure by means of the proper lower
screw. Make the electric connections. Turn the front
plate upwards and fix it by means of the proper
upper screw.
Close the front plate and fix the upper headstock to
the box (the fastening screw is freed by lifting the
special slide).
Volume adjustment and lighting
15 16
Name tag application
The name tag can be inserted from the outside.
Take off the outer plate by pressing the righthand
side and pushing outwards.
This operation releases the plexiglass plate (57 x
15,5 x 1,2 mm) and the mylar card (0,1 mm thick).
The name can be written temporarily on the card
and will be definitively engraved on the plexiglass
plate.
Reverse the procedure to replace the name card
and the external plate.
Lamp for lighting
the name tags
Internal volume
adjustment
External volume
adjustment
DS956-002B