Publicidad
Idiomas disponibles
Idiomas disponibles
List of Materials
Removing the packaging.
I CAUTION
Remove carton carefully, Wear gloves to protect against sharp
edges.
Supplied Part
Hood assembly and LED lamps already installed
4.5x13 mm
4.2x15 mm
3.5x6.5 mm
4.2x19 mm
Bottom mounting brackets
Parts not supplied
Tools/Materials required
• Level
• Drill with
⁄
" (3,2 mm drill bit)
1
8
• Pencil
• Pliers
• Tape measure or ruler
• Caulking gun and weatherproof caulking compound
• Saber or keyhole saw
• Metal snips
• Vent clamps
• Screwdrivers:
• Flat-blade
• Phillips
Parts needed
• 6" (15.2 cm) round metal vent system
Optional accessories and consumable parts
KIT
Recirculating Kit
Up to 30" width
Hood Liner
4
Pieces
1
8
2
8
8
2
#Part
28.5" (72.39 cm)
KIT02770
Up to 36" width
KIT02773
KIT02774
I WARNING
Remove the protective film covering the product before
putting into operation.
Supplied Part
Mounting brackets
Metal spacers (for use when cabinet depth is greater than 12")
3.5x9.5 mm
Torx #10 adapter
Ø 6.4x18 mm washers
Ø 4,2x12 mm washers
Location requirements:
IMPORTANT: Observe all governing codes and ordinances.
Have a qualified technician install the range hood. It is the
installer's responsibility to comply with installation clearances
specified on the model/serial rating plate. The model/serial
rating plate is located inside the liner behind the filter on the
left wall of the range hood.
Range hood location should be away from strong draft areas,
such as windows, doors, and strong heating vents.
Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance. Consult your
cooktop/ range manufacturer installation instructions before
making any cutouts.
Grounded electrical outlet is required.
See "Electrical Requirements" section.
The range hood is factory set for vented installations through
the roof or wall. For non-vented (recirculating) installations
see "Non- Vented (recirculating) Installation Through the
Soffit/Cabinet" in the "Prepare Location" section.
Recirculation Kit Part is available from your dealer or an
authorized parts distributor. All openings in ceiling and wall
where range hood will be installed must be sealed.
For mobile home installations
The installation of this range hood must conform to the
Manufactured Home Construction Safety Standards, Title
24 CFR, Part 328 (formerly the Federal Standard for Mobile
Home Construction and Safety, title 24, HUD, Part 280)
or when such standard is not applicable, the standard for
Manufactured Home Installation 1982 (Manufactured Home
Sites, Communities and Setups) ANSI A225.1/NFPA 501A, or
latest edition, or with local codes.
†®TORX is a registered trademark of Saturn Fasteners, Inc.
Pieces
2
2
6
1
8
8
Publicidad
