Publicidad
Idiomas disponibles
Idiomas disponibles
7.1 PROGRAMMING OR ADDING A COMMAND
Step 1. Connect the motor to power:
The motor will be able to perform one of the following actions depending on its current status.
A. (
y
) - Motor without any programmed emitter.
B. (
) - Motor with a programmed emitter.
Step 2.
Press "P2" 1 second (
If necessary, delete all the transmitters. Press "P2" 1 second (
and "P2" 1 second (
,
7.2 TO CHANGE THE DIRECTION OF ROTATION (IF NECESSARY BECAUSE IT
IS UPSIDE DOWN):
Hold "Up" and "Down" at the same time for 2 seconds (
rotation has been reversed. This can only be done without the programmed limit switches.
7.3 PROGRAMMING LIMIT SWITCHES
Note: When programming the limit switches, the motor operates by pressing and holding the
button of the direction in which you wish to move for 2 seconds.
Step 1. Programming the lowering limit switch
Move to the desired down position, hold the "Stop and Down" buttons simultaneously for 2
seconds (
,
y
,
Step 2. Programming the up travel limit switch
Move to the desired up position, hold down the "Stop and Up" buttons simultaneously for 2
seconds (
,
y
,
If necessary, delete the limit switches. Press "P2" 1 second (
and "P2" 1 second (
,
7.4 INTERMEDIATE STOP PROGRAMMING
The motor allows an intermediate stop to be programmed between the programmed limit
switches, and the motor is brought to the desired point. Press "P2" for 1 second (
for 1 second (
y
), and "Stop" for 1 second (
7.5 PERFORMING A COMPLETE ERASURE
For a complete deletion of the motor, it is necessary to delete the limit switches and to delete all
the transmitters as described in the previous points.
y
), "P2" 1 second (
y
,
, ). on any programmed transmitter.
, ).
, ).
y
,
, ).
y
) and "Up" (
,
y
y
), "Stop" 1 second (
), you can check that the direction of
y
), "Down" 1 second (
,
y
,
, ).
,
, ).
y
)
y
),
y
), "Stop"
33
Publicidad
