Publicidad
Idiomas disponibles
Idiomas disponibles
The product is factory assembled, all
you need to do is attach the wheel
bracket and wheels to the product:
Assembly UCL5002-24 / UCL5003-24
Fit the wheel support (6) and wheels (5)
to the water tank (4) using the 16 screws
supplied (Ø5x16cm). The process should
be carried out from the bottom of the
tank, first joining the wheel support to
the tank on the straight side (14). Then fix
the 4 wheels using the 16 smaller screws
supplied (Ø4x14cm), placing the wheels
on the appropriate part of the wheel
holder on the side of the wheel holder (15).
Assembly UCL5004-24
To
assemble
the
castors, the castors must be fixed directly
to the water tank (4). They can be mounted
using the screws supplied.
USING THE APPLIANCE
This device is easy to use and does not
require much knowledge. However, we
advise you to familiarize yourself with the
instructions below.
(
Control panel
see picture 03 on page 6)
12. On/Off.
conditioning on/off.
13. Speeds. Adjust the types of speeds,
you can select up to 3 types of
speeds, with 1 being the softest and
3 the strongest.
14. Swing mode. Activate/Deactivate
the oscillating movement of the
front blades to distribute the cold air
inside the room.
How to refill the water tank
Water must be added to the tank to activate
the cooling and humidification function.
Filling can be manual or automatic.
Manual filling. Pull out the water tank
from the bottom of the back (air cooler ),
and leak 1/3 of water tank while inject fair
water into it.
UCL5004-24
model
Switches
the
• Use clean water.
• Please note the display of water level
when injecting water .
• The water level of water tank must be
less than "max." when injecting water.
• The water level of water tank must be
more than"min."when air cooler is with
cooling and humidify.
Automatic
conditioner with a hose to the water
inlet valve and open it, in this water
filling method, you must also check
the water level, where the levels must
be between "max" and "min".
Note: The water level of water tank is less
than "MAX" after ice boxes (or ices) is put
water tank.
Ice packs
When the temperature outside is high and
you use ice packs there may appear some
water condensation in the water tank that
could leak to the floor.
• Every time to refill the water tank or
put ice packs in it, you must unplug the
appliance from the power source.
• Open the water fill funnel.
air
• Make sure the rubber plug is well fixed to
prevent any water from uncontrollably
spilling from the appliance.
• Fill the tank exclusively with clean
fresh drinking water. You can add ice
cubes made from fresh drinking water
to increase the cooling effect.
• Pay attention to the maximum and
minimum filling levels indicated by
the filling level indicator. The water
tank must be full at least to the
minimum level for the water pump
to work. Close the water fill funnel,
that is, put he evaporation filter and
the air filter back in place.
• Make sure the outside of the appliance
is not damp or wet. If it is, dry it with a
cloth.
Connect
filling.
EN
the
air
25
Publicidad
