universalblue UCL5002-24 Manual De Instrucciones página 26

ENGLISH
Cooling chamber
• The UCL5004-24 (120L) has three cold
accumulators to speed up the cooling
process. These accumulators are filled
with a special cooling gel which, once
frozen, keeps the cold much longer than
other means such as ice cubes.
Do not open or fill with
water. These bottles are
filled with a special freezing
gel
contracts
freezing
• How to use these three cold accumulators
You can place them in the cooling
compartment (10) on the top of the
appliance, this will help the air to come
out colder. You can place them in the
water tank (4), which will lower the
water temperature and speed up the
cooling process.
• The model UCL5004-24 (with the
capacity of 120 Litres), has included
three cold accumulators
ice bottles), which can be frozen and
then placed in the cold chamber
compartment (10), so that the air can
come out cold. It would have the effect
of placing ice blocks in the water tank
(4).
Inappropriate use
• Do not place the appliance on a wet or
flooded surface
• Do not put any objects on the appliance.
Do not block the air inlets and outlets.
• This appliance must not be used in the
open air.
• The appliance
enlarged or remodelled
• You may only use the appliance as
indicated in this manual, otherwise the
warranty will be void and any liability
will be extinguished.
26
that expands
during
process.
(reusable
cannot be altered,
CLEANING AND MAINTENANCE
To avoid accidents caused by
electric shock, make sure that
no power is supplied to the unit
before starting maintenance or
repair.
Air filter cleaning
If the air filter is blocked by the
accumulation of a large amount of dust,
and
the volume of the air flow will be reduced.
the
Clean the filter once every two weeks.
The frequency of cooling pad cleaning
depends on local air and water conditions.
In areas where the water has a high mineral
content, mineral deposits may build up on
the cooling pad and restrict airflow.
Emptying the water tank and filling it with
fresh water at least once a week will help
reduce mineral deposits.
Do not run the machine cold with dirty
water. Empty the tank and fill it with clean
water.
For best results, allow the cooling filter
to dry after each use by switching off the
cooling function for 15 minutes before
switching off the appliance.
Note: do not use the appliance without the
filters. Do not use it either if the filters are
blocked.
• Pull off the plug.
• Remove the grilles by removing the
corner screws with a screwdriver (see
picture 02 on page 5).
• Remove the filter and clean it with a
neutral detergent and a soft brush.
• Once clean, reassemble the side and
rear panels.
Clean water tank
• Pull off the plug.
• Allow the tank to drain completely.
• Clean any residue in the tank with a