Publicidad
Idiomas disponibles
Idiomas disponibles
For maximum effectiveness:
Make sure you have enough gel on the treatment surface (#1) at all times during the
U
treatment.
Do not leave the device on one spot of skin. Keep moving the device covering the entire
U
EN
EN
treatment area. This will prevent overheating of the treatment area, and reduce the
possibility of any adverse effect.
Make sure the 3 electrodes (#2) are always in full contact with the skin.
U
If the energy level feels uncomfortable, reduce it to a level that is comfortable for you.
U
Only change energy levels when the treatment surface (#1) is not in contact with the skin.
U
5.3 What to expect
During a treatment session it is normal to experience or feel:
A sensation of warmth.
U
Some redness or slight swelling: this should subside within a few hours, or up to one day.
U
5.4 Possible side effects
If you follow the instructions fully and pay attention to all warnings and contraindications,
complications and side effects are uncommon. However, every cosmetic treatment, including
those designed for home use, involves some degree of risk. Therefore it is important that you
understand and accept the risks and complications that may occur.
Excessive edema (swelling) and erythema (redness) are rare reactions to the treatment that,
U
in most cases, subside within a few days. In case these signs appear, immediately use a
damp cool cloth to cool the area for at least 10 minutes and apply an anti-burn cream.
In rare cases the user may experience dilation of the superficial blood capillaries. This may
U
result in a temporary redness for a few days. Also, some of the capillaries may present red
spots that will also reduce with time. If these signs appear, we recommend that you cool the
area with chilled water immediately.
Consult your physician if you experience any persistent symptoms including pain, skin
Z
redness, swelling or a burning sensation.
6. Get started!
1.
Make sure that your skin is clean and dry, and that you have removed all jewelry.
2.
Remove the device and the other components from the box.
3.
Decide if you want to use the device cordlessly or via the mains supply.
Cordless: Check that the battery is not low before you start a treatment.
y
Mains supply: Place the wall adapter cable into the wall adapter socket (#7) and
y
connect to the mains supply.
8
Publicidad
