Publicidad
Idiomas disponibles
Idiomas disponibles
6.2 Treatment steps for use on larger areas
For larger areas, such as cheeks, we recommend you use the RF attachment (#9).
EN
EN
RF attachment
1.
Place the RF attachment (#9) on the treatment surface (#1) and gently press it so that it
locks into place. Make sure that the triangular mark on the back of the attachment faces
upwards.
y
If the RF attachment is installed correctly, the battery/attachment indicator light (#6)
will be constant green during use.
y
The LED lights (#3) and Infrared lights (#4) will also be on.
If the RF attachment is not installed correctly, the battery /attachment indicator light (#6)
Z
blinks green. If that happens, re-install the attachment.
2.
Once the attachment is positioned correctly, follow the treatment steps in section 6.1
Treatment steps for use on smaller areas.
Remove the RF attachment: Gently pull the attachment outwards until it detaches from
3.
the device. Clean and dry it before storing for next use - see section 7. Cleaning, maintenance
& storage.
7. Cleaning, maintenance & storage
Clean the device and the RF attachment (#9) after each treatment.
[
Never immerse your device or any of its parts in water!
To clean the device, put the device in standby mode, then unplug it.
U
Use absorbent paper (such as toilet paper or wipes) to remove the gel residue off the
U
treatment surface (#1). Make sure you remove all gel residue to prevent the gel from
solidifying or damaging the device.
Use a clean damp cloth to clean the device and the treatment surface (#1).
U
Clean and dry the RF attachment (#9) in the same way.
U
You may use cleaning fluids with up to 70% alcohol, but never use
Z
acetone or other abrasive liquids, because they will damage your device.
U
Finally, wipe the device and the treatment surface (#1) dry with a clean
dry cloth.
10
Publicidad
