BEFORE FIRST USE
Setting Up
1.
Remove all packaging from the air fryer,
including any temporary stickers.
2.
Place the air fryer on a stable, level, heat-
resistant surface. Keep away from areas that
can be damaged by steam (such as walls or
cupboards).
Note: Leave 5 inches / 13 cm of space behind and
above the air fryer.
[Figure
in front of the air fryer to remove the basket.
3.
Wash the basket and crisper plate thoroughly,
using either a dishwasher or a non-abrasive
sponge.
Note: There may be water spots on the basket
window after washing. This is normal. Run the air
fryer for 15 minutes to completely dry the basket.
4.
Wipe the inside and outside of the air fryer
with a slightly moist cloth. Dry with a towel.
5.
Align the arrows on the crisper plate with the
arrows on the basket and push down firmly
to insert. Place the basket inside the air fryer.
[
Figure 1.2
]
Figure 1.2
10] Leave enough room
Test Run
A test run will help you become familiar with your
air fryer, make sure it's working correctly, and clean
it of possible residues in the process.
1.
Make sure the air fryer basket is empty and
plug in the air fryer.
2.
Press PREHEAT. The display will show "205°C"
and
"5
MIN".
3.
Press
to begin preheating. When
preheating is done, the air fryer will beep.
4.
Pull out the basket and let it cool for 5
minutes. Then place the empty basket back in
the air fryer.
5.
to select the Steak fuction. The
Press
display will show "205°C" and "10 MIN".
6.
Press
TEMP/TIME
on the display. Press the
change the time to 5 minutes.
Note: Optionally, press SHAKE to turn off the shake
reminder and press PREHEAT to remove preheat.
7.
Press
to begin. When finished, the air fryer
will beep.
8.
Pull out the basket. This time, let the
basket cool completely for 10–30 minutes.
Note:
•
Any air fryer may have a plastic smell from the
manufacturing process. This is normal. If the
plastic smell does not decrease after a test run,
contact Customer Support (see page 17).
•
Use caution when turning the basket over after
cooking, as the hot crisper plate may fall out
and create a safety hazard.
twice. The time will blink
—
button once to
EN
7