Setting Welding Time; Setting Mode Of Operation - Signode BXT2 Manual De Operación, Partes Y Seguridad

SIGNODE BXT2
1
➟
Fig. 13
1
3
➟
AUTO
AUTO
MAN.
SOFT
5
➟
AUTO
MAN.
SOFT
blinkend / fl ashing /
clignote
6
➟
AUTO
MAN.
SOFT
Fig. 14
20
2 3
=
+ / -
2
➟
AUTO
MAN.
SOFT
4
+ MAN.
AUTO
1.
MAN.

5.7 SETTING WELDING TIME

– Press the „Function" button (13/1) briefl y.
– Press the „Welding time" button (13/2) until the
fl ashing digital display (13/3) shows the required
welding time. Wait two seconds until the new setting is
saved.
1 = minimum welding time
7 = maximum welding time

5.8 SETTING MODE OF OPERATION

– Press „Function" button (14/1) briefl y. The digital
display will show „F" (Function). The present mode of
operation is shown.
– Then press the „Mode of operation" button (14/2)
briefl y until the desired mode of operation is shown.
Semi-Auto strapping (Standard):
Strapping is performed by pressing the tensioning button.
When the strap tension is reached, welding and cutting is
performed automatically.
– Press the „Mode of operation" button (14/2). When the
„AUTO" (14/3) and „MAN" (14/4) LED indicators light
continuous green „Semi-Auto" mode of operation is
selected.
Fully-Auto strapping:
Strapping is performed by tapping tensioning button.
Tensioning, welding and cutting are performed fully-
automatically.
– Press the „Mode of operation" button (14/2). When the
„AUTO" LED indicator (14/5) fl ashes green „Fully-
Auto" mode of operation is selected.
STOP OF FULLY-AUTO SEQUENCE:
By pressing tension- /welding button (recommended)
or raising rocker lever again.
Frequent operation of the rocker lever with
the strap under tension will lead to increased
wear on the pawl parts (Pos. 60,65/page 34).
Manual strapping (manual welding):
Strapping is performed by fi rst pressing the tensioning
button (1.). When the tension is reached, press the
welding button (2.).
2.
– Press the „Mode of operation" button (14/2). When the
„MAN" LED indicator (14/6) lights continous green
„Manual" mode of operation is selected.
11.11